Introduction

Are you tired of dealing with pesky mice in your home or workplace? If so, you're not alone. Mice can be a nuisance, causing damage to property and spreading diseases. Traditional mouse traps can be effective, but they can also be messy and inhumane. In this article, we will show you how to make an electric mouse trap using a 12V battery. This DIY project is simple, effective, and humane. Let's get started!

Materials Needed

• 12V battery
• Wire mesh
• Wooden board
• Door hinge
• Electrical wires
• Switch
• LED light
• Bait (peanut butter, cheese, etc.)

Step 1: Building the Trap

Start by constructing the trap box using the wooden board. Cut the board into four equal-sized pieces and nail them together to form a box. Make sure the box is large enough to accommodate a mouse comfortably.

Next, attach the wire mesh to one side of the box using staples or nails. This will serve as the entrance for the mouse. Make sure the mesh is securely attached and there are no gaps or holes that the mouse can escape through.

Attach the door hinge to the opposite side of the box. This will serve as the door that closes once the mouse enters the trap. Make sure the hinge is securely attached and the door can open and close smoothly.

Step 2: Wiring the Trap

Now it's time to wire the trap. Start by connecting one end of the electrical wire to the positive terminal of the 12V battery. Attach the other end of the wire to the switch.

Next, connect one end of another electrical wire to the negative terminal of the battery. Attach the other end of this wire to the wire mesh on the entrance side of the trap. This will complete the circuit.

Finally, connect the LED light to the switch. This will serve as a visual indicator to let you know when the trap has been activated.

Step 3: Baiting the Trap

Now that the trap is built and wired, it's time to bait it. Place a small amount of bait, such as peanut butter or cheese, on the wire mesh inside the trap. This will attract the mouse to enter the trap.

Step 4: Using the Trap

Once the trap is set and baited, place it in an area where you have seen mouse activity. Make sure to position the trap with the entrance facing the wall, as mice tend to run along walls.

When a mouse enters the trap, it will step on the wire mesh, completing the circuit and activating the trap. The door will close, trapping the mouse inside. The LED light will also turn on, indicating that the trap has been activated.

Conclusion

By following these simple steps, you can create an effective and humane electric mouse trap using a 12V battery. This DIY project is a great alternative to traditional mouse traps, as it is both effective and humane. Say goodbye to pesky mice and hello to a mouse-free environment!

Feb23.chat.1pass.general public.how to make an electric mouse trap with battery 12v

As an Amazon Associate, I earn from qualifying purchases.